35
4. Once the desired position has been located, se-
curely tighten the mounting bolts.
2. Test fit the top flying wires as shown, the upper
flying wires will be longer than the bottom.
3. Use the 4-40 bolt and nut to mount the flying
wires to the top of the rudder as shown. Mount-
ing hole has been predrilled.
Stab Flying Wire Installation
1. Gather the following items shown below.
◊
3 - 4-40 mounting bolts
◊
3 - 4-40 nuts
◊
4 - Premade flying wire assemblies
Note:
Flying wire installation
is not optional
. Please
be sure to follow these steps, failure to do so
will result in a stab failure.
