75
5. The rear bulkhead of the fuse has 3 small holes
laser cut on both sides of the fuse. These 3 holes
are to allow the zip ties to pass through and hold
the aileron, flap, and wing tip light extensions
for a clean installation.
6. Slide a zip tie through each of the 3 precut holes
as shown below.
3. The manual switch lighting layout is shown be-
low. This setup will be used for an external
lighting switch.
4. The electronic switch setup is shown below. Fol-
low the same wiring diagram as shown in the
above step using an electronic switch as shown.
Tail
Beacon
R. Wing
L. Wing
Switch
Switch
