14
Aileron/Flap Servo Installation
1. The ailerons/flaps have been pre-hinged and
glued to the wing panels and are ready for flight.
No other steps are necessary for hinging.
Gather (1) wing panel, (1) aileron servo, (1) Flap
Servo (8) servo mounting screws, (4) Wood
screws for mounting blocks, (2) 1 1/4” servo
arm , (2) safety clip (1) 6” servo extension (1)
18” Servo Extension and (4) Servo Mounting
blocks as shown below for preparation of the
servo installation.
WING ASSEMBLY
2. Using a Phillips screw driver remove the aileron
servo mounting hatch as shown below.
3. Use a C-Clamp to hold the servo mounting
blocks to the servo as shown. Use a block of
wood to elevate the servo mounting hatch as
shown.
4. Use a 1/16” drill bit to drill the mounting holes
for the servo mounting screws as shown.
