16
52” Aeroworks Extra 260 Freestyle Assembly Manual
4. Feed one rudder cable through the pre installed
cable exit tube in the rear of the fuse toward the
front of the fuse. Repeat for other side.
Note:
Loop or tape cable to fuse to prevent cable
from being pulled into fuse.
5. Pull the rudder cables from rear of fuse to the
rudder servo tray.
Note:
Cables run parallel down fuse and do not
cross each other.
6. Thread the brass swag tube onto the pull pull
cable followed by the threaded coupler.
7. Thread cable back through the brass swage tube
as shown.
8. Loop the cable back through the brass swage
tube and pull tight as shown.
2. Install servo in servo well with the output arm
toward the nose. Install servo with mounting
hardware provided with the servo.
3. Tape the rudder balance tab to the top leading
edge of the vertical fin in the neutral position as
shown. This ensures the rudder is straight when
the cables are attached.
