12
52” Aeroworks Extra 260 Freestyle Assembly Manual
14. After the CA hinges have been placed in the ele-
vator slide the hinges into the stab. Once again it
is very important that the hinge stay straight.
15. Remove the T-pins from each hinge. Check ele-
vator throw before gluing to ensure full deflec-
tion is possible. Using a new bottle of thin CA
apply 3-4 drops on each side of the hinge. Be
careful not to over soak the hinges with CA this
can cause failure.
Note:
Always use a fresh bottle of CA. Old CA will
not cure and can cause failure.
16. Use 80 Grit Sandpaper to scuff the carbon con-
trol horn where it will be glued to the elevator as
shown below.
17. Test fit elevator control horn before gluing, ad-
just fit if necessary.
18. Apply Thick CA inside the elevator control horn
slot.
12. Once satisfied with the stab alignment, the stab
can be glued in place as shown. Use thin CA
with an applicator tip to wick CA into the stab
joint as shown. Do not use accelerator for glue
as this will weaken the glue joint.
13. Center all 6 hinges in the pre-cut hinge slots us-
ing T-pins. Make sure that each hinge is straight
to prevent binding.
