50
Chapter 2
www.aerotech.com
2.3.6. Brake Output (J207)
The Brake Output pins provide a direct connection to either the solid state relay on the Soloist HPe 150/200
or the mechanical relay on the optional -IO board. The brake output pins in J207 permit the brake to be wired
with other signals in the feedback cable. The brake is configured for automatic or manual control using
controller parameters (refer to the Soloist Help file for more information).
Use either the solid state relay on the Soloist HPe 150/200 or the mechanical relay on the -IO board when
connecting a power supply to the brake outputs on J207. Do not use both relays at the same time.
Refer to
for more information on using the brake output with the solid-state relay.
Refer to
for more information on using the brake output with the mechanical relay.
Table 2-16:
Brake Output Pins on the Motor Feedback Connector (J207)
Pin#
Description
In/Out/Bi
13
Brake Output -
Output
25
Brake
Output
Soloist HPe 150/200
Installation and Configuration
