___________________________________________________________________________________________________
SKY-8101 Manual V04 20180321
Copyright 2018 Advantech Co. Ltd. All rights reserved.
Page 17
After all screws have been inserted, hand tighten them using a PH2 screw driver to
ensure secure installation. Ensure the rack is adequate for the unit (weight) and the
application.
Use the mounting hardware recommended by the rack manufacturer to mount the unit
in the rack. For mounting screws, compatible with the rack design, must be used
and hand tightened to ensure secure installation.
While Advantech does not supply support brackets, slide rails are available for
separate order. Please refer to
for options. Choose a mounting location
where all four mounting holes line up with those of the mounting bars of the 19-inch
cabinet.
Choose a mounting location that does not block any air inlet and air outlet areas of
the unit, it is also recommended to factor in heat generated by adjacent equipment
and to avoid exposure to direct sunlight when mounting the unit. If installed in a closed
or multi- unit rack assembly, the operating ambient temperature of the rack
environment may be greater than room ambient. Therefore, consideration should be
given to installing the equipment in an environment compatible with the maximum
recommended ambient temperature.
Route cables away from power lines, fluorescent lighting fixtures and sources of noise.
Make sure that cables do not block air inlet and outlet areas. Reliable grounding of
rack-mounted equipment must be maintained.
1.3.2 Chassis Slide Rail Installation
To install the chassis slide rail on the SKY-8101S chassis, please follow below instruction.
Step 1: Remove the chassis (inner) member
Summary of Contents for SKY-8101
Page 2: ......
