___________________________________________________________________________________________________
SKY-8101 Manual V04 20180321
Copyright 2018 Advantech Co. Ltd. All rights reserved.
Page 14
6. Position the power cord so that people cannot step on it. Do not place anything
over the power cord.
7. All cautions and warnings on the equipment should be noted.
8. If the equipment is not used for a long time, disconnect it from the power source to
avoid damage by transient over-voltage.
9. Never pour any liquid into an opening. This may cause fire or electrical shock.
10. For safety reasons, the equipment should be opened only by qualified service
personnel.
11. If one of the following situations arises, get the equipment checked by service
personnel:
12. The power cord or plug is damaged.
13. Liquid has penetrated into the equipment.
14. The equipment has been exposed to moisture.
15. The equipment does not work well, or you cannot get it to work according
- The equipment has been dropped and damaged.
- The equipment has obvious signs of breakage.
Note!
Do not leave this equipment in an environment where the storage temperature
may go beyond the range specified in
. This could
damage the equipment. The equipment should be in a controlled environment.
Caution!
Danger of explosion if battery is incorrectly replaced. Replace only with the
same or equivalent type recommended by the manufacturer, discard used
batteries according to the manufacturer
’s instructions.
16. The sound pressure level at the operator
’s position according to IEC 704-1:1982
is no more than 70 dB (A).
DISCLAIMER:
The set of instructions is given according to IEC704-1. Advantech
disclaims all responsibility for the accuracy of any statements contained herein.
1.1.2 Safety Precautions – Static Electricity
Follow instructions below to protect yourself from harm and the products from damage:
1. Be sure you are at an ESD workstation, or grounded with an ESD strap before
opening the top cover or installing/removing any unit accessible from the outside.
Doing so will discharge any static electricity that might have built up in your body.
The SKY-8101S supports an ESC Ground lug for grounding of service and
other
technical staff at location B (see
for location).
2. Don
’t touch any components inside the system while the system is on.
3. Disconnect power before making any configuration changes. The sudden rush of
power as you connect a jumper or install a card may damage sensitive electronic
components.
Summary of Contents for SKY-8101
Page 2: ......
