Advantech EKI-7706 Series, User Manual

Page: 25 / 165

12 EKI-7706 Series User Manual
4. Align the wall mounting plate on the rear side. The screw holes on the device
and the mounting plate must be aligned, see the following illustration.
5. Secure the wall mounting plate with M3 screws, see the following figure.
Figure 2.5 Installing Wall Mount Plates
Once the wall mounting plate is secured on the device, you will need to attach
the wall screws (x3).
6. Locate the installation site and place the switch against the wall, making sure it
is the final installation location.
7. Use the wall mount plates as a guide to mark the locations of the screw holes.
8. Drill four holes over the four marked locations on the wall, keeping in mind that
the holes must accommodate wall sinks in addition to the screws.
9. Insert the wall sinks into the walls.
10. Insert the screws into the wall sinks. Leave a 2 mm gap between the wall and
the screw head to allow for wall mount plate insertion.
Figure 2.6 Securing Wall Mounting Screws
Note!

Make sure the screws dimensions are suitable for use with the wall
mounting plate.

Do not completely tighten the screws into the wall. A final adjust-
ment may be needed before fully securing the wall mounting plates
on the wall.
4.5 mm
3.0 mm
2.0 mm