2.2.2.1. DC Brush Motor Phasing
A properly phased motor means that the positive motor lead should be connected to the ØA motor
terminal and the negative motor lead should be connected to the ØC motor terminal. To determine if
the motor is properly phased, connect a voltmeter to the motor leads of an un-powered motor:
1. Connect the positive lead of the voltmeter to the one of the motor terminals.
2. Connect the negative lead of the voltmeter to the other motor terminal.
3. Move or rotate the motor in the positive or clockwise (CW) direction by hand.
Figure 2-16:
Positive Motor Direction
4. If the voltmeter indicates a negative value, swap the motor leads and move the motor by hand in
the positive direction, again. When the voltmeter indicates a positive value, the motor leads have
been identified.
5. Connect the motor lead from the positive lead of the voltmeter to the ØA motor terminal on the
XC4. Connect the motor lead from the negative lead of the voltmeter to the ØC motor terminal
on the XC4.
For Aerotech-supplied systems, the motor, encoder and Hall sensors are correctly configured and
connection adjustments are not necessary.
www.aerotech.com
43
XC4 Hardware Manual
2.2.2. DC Brush Motor Connections
Summary of Contents for Automation1 XC4
