Advanced Energy AE 3TL 1000 Series, Installation And Operation Manual

Page: 45 / 126

8. Lift the inverter using the four side handles and hang it on the wall mount
bracket hooks by aligning the mounting points on the rear of the heatsink.
☞
Important
Due to the weight of the inverter, AE recommends using two people to
lift the inverter and hang it on the wall mount bracket. Follow local or
OSHA guidelines when lifting or moving equipment.
The lower end of the heatsink should rest against the support on the bottom
front of the wall mount bracket.
Heatsink cooling fins
Lower edge of heatsink
Figure 4‑4. Mounting the inverter on the wall mount bracket
9. Fasten the heatsink to the wall mount bracket using two washers and two of the
included screws.
Table 4‑1. Construction anchoring chart
Wall Structure Fasteners Notes
Concrete masonry unit
(CMU) (full grout or hollow
core) 4 fasteners: 3/8" diameter
expansion anchors Embed the four fasteners a
minimum of 6 cm (2.5"). Follow
the manufacturer instructions. All
fasteners must be installed with
fender washers.
Advanced Energy® AE 3TL Inverters
570-1003552-05A Installing 4‑9