Ending Calls
Using Aastra 480i CT Phone Features
16
Copyright © 2009 ADTRAN, Inc.
619500100-1A
6
When the receiving party answers the call, press the Xfer button to complete the transfer.
If instead you would like to cancel the transfer and return back to the original caller, drop the current
call by pressing the Drop soft key, then press the line/call appearance button for the held call.
2.8 Ending Calls
To end a call, make sure you are connected to a call, and press the on-hook button or the line/call
appearance button of the active call. If you are connected through the handset, you can also place the
handset back on hook to end the call.
2.9 Redialing
Press the Redial button to automatically dial the number that was most recently dialed from your
telephone.
2.10 Forwarding Calls
The call forwarding feature on the IP phone allows incoming calls to be forwarded to another destination.
The phone sends the SIP message to SIP proxy, which then forwards the call to the assigned destination.
Call forwarding is disabled by default. You system administrator can enable call forwarding on a phone-
wide basis or on multi-line phones on a per-line basis. If you have configured call forwarding on an
individual line, then the settings for this line are used; otherwise, the phone-wide call forward settings are
used. You can have up to 9 lines configured for call forwarding.
The following are the modes you can configure for call forwarding:
Setting call forwarding
You can configure phone-wide call forwarding.
Table 2–1: Call forwarding modes
Call Forward Mode Description
Off
Disables call forward
All
Phone forwards all incoming calls immediately to the
specified destination
Busy
Phone forwards incoming calls if the line is already in use
No Answer
Phone forwards the call if it is not answered in the specified
number of rings
Busy No Answer
Phone forwards the call if either the line is already in use or
the call is not answered in the specified number of rings.
Global
Phone uses the phone-wide call forward setting. This is only
valid when setting the mode of individual lines.
