12
•
Installation
2.3
Hardware Installation
2.3.1
Hardware configuration
PCI-8136M has plug and play PCI controller on board. The memory usage
(I/O port locations) of the PCI card is assigned by system BIOS. The address
assignment is done on a board-by-board basis for all PCI cards in the system.
2.3.2
PCI slot selection
Your computer will probably have both PCI and ISA slots. Do not force the
PCI card into a PC/AT slot. The PCI-8136M can be used in any PCI slot.
2.3.3
Installation Procedures
1.
Read through this manual, and setup the jumper according to your
application.
2.
Turn off your computer, Turn off all accessories (printer, modem,
monitor, etc.) connected to computer.
3.
Remove the cover from your computer.
4.
Select a 32-bit PCI expansion slot. PCI slots are short than ISA or
EISA slots and are usually white or ivory.
5.
Before handling the PCI-8136M, discharge any static buildup on your
body by touching the metal case of the computer. Hold the edge and
do not touch the components.
6.
Position the board into the PCI slot you selected.
7.
Secure the card in place at the rear panel of the system unit using
screw removed from the slot.
2.3.4
Trouble shooting:
If your system won't boot or if you experience erratic operation with your PCI
board in place, it's likely caused by an interrupt conflict (perhaps because you
incorrectly described the ISA setup). In general, the solution, once you
determine it is not a simple oversight, is to consult the BIOS documentation
that come with your system.
Summary of Contents for PCI-8136M
Page 1: ...PCI 8136M 6 Axis Motion Controller Card User s Guide ...
Page 2: ......
