User manual MKA 120
Conforms to
Issue 07.07.2021_01 Page 26
If the program and step number are displayed during operation
, you can use the “Line” button
to select the step number. Once you have selected a step number (Stp: 1 is flashing), you can
use the arrow buttons „up“ or „down“ to select the required step number.
When you
have selected a step number, press the „Line“ button again to start this step
The step will be started immediately after you have pressed the „Line“ button.
8.3 Status bar
Different fixed messages, relay states, batch number, program/step number or the current time
of day can all be shown on the status bar.
Use the arrow button to make changes to the status bar display.
Hint
The buttons are used to skip between the different lines on the status bar.
You can only skip between lines when nominal values are not focussed.
.....
8.3.1 Messages (system status messages)
Here all the messages that have been configured for this process or program are shown,
together with their current status.
Hint
Messages are for information only and are
not
sent to the „VisuNet“ recording program.
8.3.2 Alarms
Here all the alarm signals that have been configured for this process or program are shown,
together with their current status.
Hint
Alarm
s are critical operating states, which are sent to the„VisuNet“ recording program and
logged.
Hint
If you do not want the controller to skip into the next step , press either shortcut buttons I,II
or III.
Changing
nom. values
Changing
nom. values
