ADC Campus-REX2 RS, User Manual

Page: 58 / 166

Chapter 3 - Configuring the REX2
46 Campus-REX2 RS Interface Card User Manual
•
If the Campus-REX2 is connected to a Campus unit with a
synchronous interface card, such as a Fractional V.35 card, the
timing source depends on the setting of the Primary Timing Source
option of the remote unit:
–
Set the Timing Source to HDSL if the remote unit is set to
Internal or Data Port.
–
Set the Timing Source to Internal if the remote unit is set to
HDSL.
See the Campus-RS Fractional Interface Card User Manual for
information on the Primary Timing Source option.
•
If the Campus-REX2 is connected to a Campus unit with a Campus
CSU/DS-1 or CSU/DSX-1 interface card, set the Timing Source
option to Internal.
Configuring Routing Features
This section provides procedures for configuring routing features such as
LAN and Line IP addresses and subnet masks, RIP configuration for dynamic
routing, static routing configuration, and DHCP services. See
“IP Routing”
on page 126 for more information about the routing implementation for the
Campus-REX2.
To configure the router, from the REX2 Configuration and Status screen type
then press . The Router Configuration screen is displayed. 4 ENTER
May 05, 2003 ADC TELECOMMUNICATIONS, CAMPUS RS, Version 4.6D 15:07:12
Local Unit ID: Local I/F: REX2
Remote Unit ID: Inactive Remote I/F: Inactive
Circuit ID:
ROUTER CONFIGURATION
1) IP ADDRESS CONFIGURATION
2) RIP CONFIGURATION
3) STATIC ROUTE CONFIGURATION
4) DYNAMIC ROUTE TABLE
5) STATIC ROUTE TABLE
6) ARP TABLE
7) DHCP SERVICES
(R)eturn (M)ain Menu
ENTER CHOICE>