ADC Campus-REX2 RS, User Manual

Page: 34 / 166

Chapter 2 - Configuring HDSL Parameters
22 Campus-REX2 RS Interface Card User Manual
Using Standard Mode
Standard mode is the default configuration for the HDSL operating mode.
When standard mode is selected, only three HDSL rates (T1, E1, and 768) are
available. You can select any of the three options for transceiver mode,
however.
1 From the HDSL Parameters menu, type then press if the
HDSL Operating Mode is set to Extended. Standard is now displayed as
the HDSL Operating Mode.
2 To change the Transceiver Mode, type then press . The
Transceiver Mode changes to the next setting. Repeat until the preferred
setting is selected:
•
Master initiates the HDSL link. The other Campus unit must be set
to Slave or Auto.
•
Slave waits for the other Campus unit to initiate the HDSL link. The
other unit must be set to Master or Auto.
•
Auto (default) automatically switches between Master and Slave
until an HDSL link is established.
The Transceiver Mode option determines the hierarchy of the two
Campus units when attempting to establish an HDSL link.
3 To change the HDSL Rate, type then press . The HDSL Rate
changes to the next setting. Repeat until the HDSL Rate is set to the
preferred setting of T1 (default), E1, or 768.
4 Type to save and apply HDSL changes as prompted by:
Enter (S)ave to apply changes !
5 To exit the menu, type (go back one screen) or (return to the Main
Menu).
It is recommended that you leave the Transceiver Mode
option set to Auto unless you require that a particular end of
the HDSL connection be the Master or Slave.
Also, this value cannot be changed if the HDSL link is up.
1 ENTER
2 ENTER
3 ENTER
S
R M