3-5
Installing the DuraStor Storage Subsystem
4
Slide one of the rack’s mounting rails into the slot on the left side
of the RAID appliance’s back panel. See
Figure 3-8
.
Push the rail in until it fits the depth of the rack. The rail should
mate with mounting slots on the rack’s rear vertical member and
make the appliance level and tight-fitting.
Figure 3-4 Attaching the Rails
5
Secure the left side rail to the rack’s rear vertical member using
the screws and nuts.
6
Repeat steps 6 and 7 for the other side rail.
Note:
Be sure that the RAID appliance is level. Check that
you used mounting slots of the same height on both sides
of the rack.
7
Reinstall the PSUs. See
Replacing a Power Supply Unit
on
page 5-5
.
GRAPHIC GOES HERE
Ext
Int
HOST OUT (CH 0)
HOST OUT (CH 3)
HOST IN (CH 0)
HOST IN (CH 3)
DISK CH 2
DISK CH 1
SERIAL B
SERIAL A
Nut
Threaded Stud
Mounting Rail
Rear Rack Vertical
Screws
Nuts
Mounting
Slot
Rail Slot
DuraStor IUG.book Page 5 Wednesday, January 30, 2002 10:49 AM
