5-3
Maintaining the DuraStor Storage Subsystem
6
Slide the controller canister into the open bay until the latches
hook onto the anchors.
Caution:
Be sure the latches are hooked into the anchors,
and
be gentle
as you complete the installation. The pins that
the controller mates with inside the DuraStor RAID
appliance are very fragile and bend easily.
7
Using your thumbs, push both latches into their locked position.
The controller canister automatically slides the rest of the way
into the bay and locks into place.
8
Replace the front bezel. See
Replacing the Front Bezel
on page 3-6
.
The Fault LED goes out and the Controller Status LED flashes
and then becomes solid to show normal controller status.
Replacing a Down Controller When in Active-Active Mode
Note:
Active-active mode is only available when there are
two controllers installed in the DuraStor RAID appliance.
Refer to the
Adaptec Storage Manager Pro User’s Guide
for
more information on operating modes.
If one controller detects that the other has a problem, it will kill it
and output an event on the system monitor. The Fault LED will
light up, the Controller Status LED will light up, and the audible
alarm will sound.
If the down controller has a permanent failure, you must replace it.
See
Replacing a RAID Controller
on page 5-2
.
!
!
DuraStor IUG.book Page 3 Wednesday, January 30, 2002 10:49 AM
