4-9
Novell NetWare Installation
Using the Load Command Line Options
You can specify several command line options when the driver is
loaded. The available options are described in the table below. This
table describes command line options for the
adpt160m.ham
driver
for Ultra160 products.
adpt160m.ham Command Line Options
Option
Values
Default
Description
auto_disable_tagq=
on, off
off
Enables/disables auto
disable tagged queuing
algorithm.
dev_enable=
0-FFFF
FFFF
Allows you to enable the
driver's registration of
SCSI devices on a per
target basis. By default, all
targets are scanned. A bit
value of 0 causes the
target not to register
under the operating
system. These devices are
still accessible via ASPI.
This enable bit mask is
entered in hex (see Bit
Mask Options on
page 4-11).
flush_diskreq=
0-FFFF
0
A bit mask to send
occasionally ordered tags
to specific targets. By
default, no targets receive
occasionally ordered tags.
This bit mask is entered in
hex (see Bit Mask Options
on page 4-11).
instr=
on, off
off
Enables/disables
recording of I/O statistics.
