© Adam Equipment Company 2020
9
3.3
SETTING UP THE SCALES
•
The pillar is attached to the base using a bracket that must be attached to the base
frame first using the 4 bolts supplied. The pillar is secured to the bracket using 2
sets of screws. The cable from the base to the indicator module is run through the
tube and taken out through the plastic support at the top. Excess cable can be
stored within the tube.
•
The GBK/GFK-Mplus series comes with a stainless steel platform packed
separately. Place the platform in the base.
•
Level the scale by adjusting the four feet. If the scale rocks re-adjust the feet.
•
Attach the indicator module to the pillar by sliding it over the bracket with the
flanges engaged in the groves on the base. Attach the cable from the base to the
connector on the rear of the indicator.
•
Attach the power to the indicator. Press the [On/Off] key. The software revision
number will be displayed followed by a self-test showing all digits before the zero is
displayed along with the unit of weight that was selected last.
•
If the scale is an approved version, GBK/GFK-Mplus, and the Calibration Counter
has been enabled (see section 6) the current values will be displayed. These
values should match the values marked on the scale at the time of verification, if it
has been verified.
Summary of Contents for GBK 150Mplus
Page 1: ...Adam Equipment GBK Mplus GFK Mplus Series...
Page 3: ......
