Adam GBK 150Mplus, Manual

Page: 19 / 44

© Adam Equipment Company 2020
19
10.5.1 SETTING UP WHILE WEIGHING
•
Press the [Low Limit] key. It will show the current low limit. The “LO” symbol will
appear on the display.
•
Press the [CE] key to clear the old value and then enter the new low limit using the
numeric keys. The decimal point is fixed at the position that is used for the current
weighing unit. When the desired value is shown press [Tare] to accept the value. If
you want to reset the value to zero, press [CE] to clear the value.
•
The limits are displayed in the weighing unit in use.
•
To set the high limit press [High Limit], the display will show the high limit, the “HI”
symbol will be on to the left side of the display. Set the high limit in the same way
the low limit was set.
•
Pressing the [Tare] key to enter the value will return the scale to weighing, with the
Check-weighing function enabled.
10.5.2 SETTING UP WHILE PARTS COUNTING OR % WEIGHING
During parts counting and percent weighing the limits are set in the same way as above.
The limits are displayed in pcs or %.
See Section 10.4 for the description of parts counting and Section 10.7 for percent
weighing.
NOTE:
1. The weight must be greater than 20 scale divisions for the check-weighing to
operate.
2. To disable the check weighing function, enter zero into both the limits as described
above. When the current limits are shown, press [CE] to clear the settings, then
press [Tare] to store the zero values.