Active AGi2100, User Manual, Page: 50 / 200

50
Oil warning light (RED)
When the oil level falls below the
lower level, the oil warning light
comes on and the engine stops
automatically. Unless you refill with
oil, the engine will not start again.
Overload indicator light (RED)
The overload indicator light comes
on when an overload of a
connected electrical device is
detected, the inverter control unit
overheats, or the AC output voltage
rises. If this happens, the AC
protector will trip, stopping power
generation in order to protect the
generator and any connected
electric devices. The AC pilot light
(Green) will go off and the overload
indicator light (Red) will stay on, but
the engine will continue running.
TIP:
If the engine stalls or does not start, turn the engine switch to “ON” and then pull the
recoil starter.
If the oil warning light flickers for a few seconds, the engine oil is insufficient. Add oil and
restart.
When the overload indicator light comes on and power generation stops, proceed as
follows:
1. Turn off any connected electric devices and stop the engine.
2. Reduce the total wattage of connected electric devices to within the rated output.
3. Check for blockages in the cooling air inlet and around the control unit. If any blockages
are found, remove.
4. After checking, restart the engine.
TIP:
The overload indicator light may come on for a few seconds at first when using electric
devices that require a large starting current, such as a compressor or a submergible pump.
However, this is not a malfunction.
5. CONTROL FUNCTION: