ACS-CONTROL-SYSTEM GmbH
l Lauterbachstr. 57 l D-84307 Eggenfelden l www.acs-controlsystem.de l [email protected]
20
5. Setting up the device
18
Menu level
Parameterisation level
Special function [O]-key,
tASt.4:
Default:
no
For the operation mode, special functions can be deposited on the
[O]-
key. This function is
activated by pressing the key. With
tArA
the device is set temporarily on a parameterised value.
The device acknowledges the correct taring with
oo0oo
in the display.
Set.tA
adds a defined
value on to the currently displayed value. Via
totAL
the current value of the totaliser can be
displayed, after this the device switches back on the parameterised display value. If
tot.rE
is
deposited, the totaliser can be set back by pressing the navigation keys
[
▲
] [
▼
]
, the device
acknowledges this with
ooooo
in the display.
EHt.rE
deletes the min/max-memory. If
HOLD
has
been selected, the moment can be hold constant by pressing the
[O]-
key and is updated by
releasing the key.
Advice:
Hold
is activated only, if
HOLD
was selected under parameter
DISPL
.
ActuA
shows the measuring value, after this the device switches back on the parameterised
display value. The same goes for
AVG
, here the sliding average values will be displayed. A
sensor calibration is done by triggering of the digital input via
se.cal
, the flow diagram is shown
in
chapter 9
. The constant value
const
can be recalled via the digital input, or changed digit per
digit. At
AL-1
…
AL-4
an output can be set and therewith e.g. a setpoint adjustment can be done. If
no
is selected, the
[O]-
key is without any function in the operation mode.
Special function digital input,
dIG.In:
Default:
no
In operation mode, the above shown parameter can be laid on the optional digital input, too.
Function description see
tASt.4
.
Back to menu group level,
rEt
:
With
[P]
the selection is confirmed and the device changes into menu group level
„–fct–“
.
…
…
