ACOEM Met One Instruments GAS-1060, User Manual

Page: 44 / 164

Serinus 60 User Manual 3.0
Page 44
Set Point (FLOW)
[Internal Pump Option]
The temperature set point of the flow block. The factory default is
50 °C.
Cell Displays current temperature of the measurement cell.
Flow Block
[Internal Pump Option]
Displays current temperature of the flow block.
Chassis Displays the temperature of air inside the chassis, measured on
the main controller PCA.
3.4.6 Pressure & Flow Menu
Main Menu

Analyser State Menu

Pressure & Flow Menu
Pressure Units Select the units that the pressure will be displayed in ( torr , PSI ,
mBar , ATM or kPa ).
Ambient Current ambient pressure.
Cell Current pressure within the measurement cell.
Internal Pump
[Internal Pump Option]
Current pressure within the flow block.
Flow Units Select the units that the sample flow will be displayed in ( slpm or
L/min ).
Sample Flow Indicates the gas flow through the sample port of the instrument.
The value should be ~0.50 slpm. If there is an error with the
sample flow, it will read 0.00 slpm.
3.4.7 Voltage Menu
Main Menu

Analyser State Menu

Voltage Menu
Signal Voltage This is the signal voltage reading.
+5V Supply +5 V power supply.
+12V Supply +12 V power supply.
+Analog Supply +12 V (primary) power supply. The value should be within ±2 V.
-Analog Supply -12 V (primary) power supply. The value should be within ±2 V.
3.4.8 General Settings Menu
Main Menu

General Settings Menu
Decimal Places Select the number of decimal places (0-5) used for the
concentration displayed on the home screen.
Conc. Units Sets the concentration units ( ppm , ppb , ppt , mg/m3 , μg/m3 or
ng/m3 ).