Selecting the “User” Option
There are cases when you cannot use the option
Auto
, instead you
have to select
User
. Choose the
User
option when you have installed
an IDE hard disk that was previously formatted but does not use the
disk native parameters or structure, that is, the disk type may be in the
IDE hard disk types list but the number of cylinders, heads, and
sectors differ.
Follow these steps to configure an IDE hard disk with the User option:
1.
Highlight an IDE drive parameter.
2.
Select the option
User
and press
.
3.
Type in the number of cylinders, heads, and sectors of the drive
under the appropriate columns.
Be sure to have the correct IDE hard disk
drive information beforehand.
4.
Choose
YES
when asked if you want to save CMOS data.
2.2.4
System Memory
The system automatically detects the total amount of onboard memory
during the POST and sets the memory parameters accordingly. If you
install additional memory, the system automatically adjusts the Total
Memory parameter to display the new memory size.
2.2.5
Math Coprocessor
The CPU includes a math coprocessor so this parameter shows
Installed
by default.
2-
8
User’s Guide
Summary of Contents for V55LA
