1.4.3
Reconfiguring the System
You must enter Setup after installing or removing SIMMs to
reconfigure the system.
Follow these steps to reconfigure the system:
1.
Turn the system on. A memory error message appears,
indicating that the total memory does not match the value stored
in CMOS.
2.
Press
+
+
to enter Setup. A warning message
appears indicating an incorrect memory configuration.
3.
Press
twice to exit and reboot the system.
The system boots with the new memory configuration.
1.5
IDE Hard Disk Support
The system board supports four IDE hard disks, or any other IDE
devices, through the two onboard PCI IDE interfaces. See Figure 1-1
for the location.
Follow the instructions in the housing installation manual on how to
install a hard disk in the system. Connect the cables according to the
IDE hard disk configuration in Table 1-9.
Table 1-9
IDE Hard Disk Configuration
IDE Connector
Master
Slave
Channel 1
Hard disk 0
Hard disk 1
Channel 2
Hard disk 2
Hard disk 3
System Board
1-
17
Summary of Contents for V55LA
