ProPanel Classic
Page 35 of 44
Pr4
– Display Resolution
[1, 2, 3 or 4]
This parameter sets the number of places to the right of the decimal point
displayed on the Readout. When the Readout is in a decimal mode (in, mm or
cm), it will auto-range to the next lower resolution if the value is too large to be
displayed in the current setting but is displayable in a lower resolution.
Default Value = 3
NOTES
:
Decimal inches have a maximum of 3 decimal places (4 .0005).
Millimeters have a maximum of 2 decimal places
This option has no effect when displaying fractions.
Pr5
– Movement to Wake Readout
[0.10 to 10mm]
This parameter sets the amount of jaw movement required to automatically
wake up the Readout when it is turned off or in sleep mode.
Default Value = 0.10mm
Pr6-10 NOT USED
Pr11
– Displayed Measurement Units
[0 to 6]
This parameter controls the type of measuring units the Readout displays
when the
UNITS
key is pressed. The table below illustrates the possible
combinations of measuring units that will be displayed by changing this
parameter.
FACTORY SET FOR PROPANEL TO 2
Pr 4 Setting
Display Resolution
1
x.x
2
x.xx
3
x.xxx
4
x.xxxx
Pr 11 Setting
Displayable Units
0
All inch units and millimeters
1
Millimeters only
2
Decimal inches and millimeters
3
Decimal inches and centimeters
4
All inch units and centimeters
5
Centimeters only
6
Decimal inches only
