ProPanel Classic
Page 13 of 44
Keys
On/Off Key
Momentarily
depress the
ON
/
OFF
key to turn the Readout on or off.
(The Readout Firmware version displays for two seconds at power-on.)
Units Key
Momentarily
depressing the
UNITS
key will display measurement/position
information in inches, fractions or millimeters (or centimeters). With each key
press, the readout will cycle through decimal inches, fractions (16ths, 32nds,
64ths) and millimeters (or centimeters). To set the measurement modes that
are displayed when pressing the
UNITS
key use
Fractional Inch mode is disabled on ProPanel Systems
When the Readout is in fraction mode, a series of
“bars” in the upper right corner of the LCD may appear
each
representing 1/64th of an inch. (ie. When in 1/16 inch mode and three
bars appear, the measurement displayed is rounded
down
to the closest 1/16
inch and each illuminated bar indicates an additional 1/64 of an inch of
additional measurement.) For better resolution, switch to 1/32 or 1/64 mode.
For the best resolution, switch to a decimal mode.
In Fractions mode, when the measurement is greater than
99 63/64 inches, +100 and/or +200 will illuminate in the upper right portion of
the LCD to indicate this amount must be added to the displayed reading. (ie: If
the measurement is 154 5/8 inches, 54 5/8 and +100 will appear on the LCD,
If the measurement is -307 23/64 inches, - 7 23/64, +100 and +200 will
appear on the LCD.
Momentarily Depress
Momentarily Depress
