19. Insert the hex head bolts and washers through the tabs located at the front and back of the upper tank bracket
through the cross member above. (Figures 24, 25)
FIGURE 24
FIGURE 25
20. Hang the lower tank bracket using the front two bolt hole locations and the 19mm bolts removed earlier. This will
allow access to reconnect tubing to its original location. Route the compressor wires and purge solenoid wires to the
rear of the bracket. (Figure 26)
FIGURE 26
21. After making tubing connections, finish installing the lower bracket to the upper using the rest of the 19mm
hardware removed earlier. (Figure 27)
FIGURE 27
27
28
AA-4397 Installation Manual
REV 01 | 05/25/2023
WIRING
