NOTE:
It may be necessary to turn steering wheel to align track rod end with mount.
Check front of vehicle to make sure body is centered over front tires/wheels. Using a measuring tape, measure
from inside of tire to frame on driver side. Then measure passenger side.
Compare two measurements; the aim is to make both sides equal.
NOTE:
If driver side measurement is greater than passenger side, track bar needs to be lengthened. If passenger side measurement is
greater than driver side, track bar needs to be shortened.
Remove adjustable rod end of track bar, loosen jam nut using a 1-1/8” wrench & turn rod end to adjust in or out.
Once body is properly aligned over front tires/wheels, tighten OEM hardware using a 21mm socket/wrench.
Fully tighten all OEM hardware at upper frame mount & axle mount. Fully tighten jam nut of adjustable front
track bar using a 1-1/8” wrench.
NOTE:
Save all factory components and hardware for reuse, unless noted.
1. Chock front tires/wheels. Raise rear of vehicle & support frame rails using jack stands at indicated lift points in
OEM service manual.
2. Remove rear tires/wheels using a 22mm socket.
3. Remove OEM rear sway bar end link using a 6mm hex key socket/wrench & 18mm socket/wrench. (Figure 89)
Install rear OEM sway bar end links on front.
FIGURE 89
63
64
AA-4397 Installation Manual
REV 01 | 05/25/2023
FRONT INSTALLATION
REAR INSTALLATION