ABL eMC2, Manual, Page: 27 / 44

TAkINg INTO OpERATION ANd ChARgINg pROCEduRE
23
• Ensure that the eMC2 has been installed according to the instructions in this docu-
ment: Check especially that there is free access to the charging pole and that an
electric vehicle can be connected without any strain or other encumbrance on the
charging cable.
• Ensure that the eMC2 is properly connected to the power supply.
• Ensure that the power supply is secured by a suitable RCCB.
• Ensure that the door of the
eMC2
is always locked during normal operation.
• Ensure that the external charging cable is not twisted and check that cable, connec-
tors, housing and charging sockets are not visibly damaged.
Preparing access control via RFID
(model variants with RFID module only)
If your eMC2 model variant has an integrated RFID card reader, you can set up user
identification to restrict or allow access to the charging process for a defined use
group. Registration at the eMC2 is via RFID compatible transponders and/or RFID ac-
cess cards, which you can obtain from the operator of your user portal.
Programming and registration of RFID access are via the central RFID module built
into the top section of the eMC2 . During programming, registration and operation,
status and feedback information from the RFID module is displayed by one blue and
one green LED.
Before you can carry out a charging process using the
eMC2 , you must register the
ID tag cards supplied (or separately obtained) with the RFID module of your charging
pole. To do so, proceed as follows:
1. Check the status of the charging pole via the
LEDs in the RFID module: When the charging
pole is ready for operation, the blue LED will
flash every 10 seconds.
flashes every 10
seconds
2. Hold one of the ID tag cards in front of the mod-
ule.
• If the card is already registered, the green
LED will flash once and then stay on for
a short period. To re-register this card, it
must first be erased.
flashes once illuminated
• If the card has not yet been registered,
the blue LED will flash once and then stay
on for a short period. This card can now
be registered.
flashes once illuminated
If you have questions or problems with registration, please contact the operator of
your user portal.