ABL eMC2, Manual, Page: 14 / 44

INTROduCTION
10
PLEASE NOTE:
Mechanical installation is identical for all
eMC2
model variants. Varia-
tions in the steps for electrical installation only arise from the integration
of separately available modules (e.g. photovoltaic system or load man-
agement module, if supported).
For identification, the model code (EMC
XXXX) as well as the power supply ratings
(voltage, frequency, current) indicated below
it are especially relevant.
If the charging pole includes an internal GSM
ready component, its respective CEXXXX No-
tified Body identifier is indicated on the serial
plate.
You can find detailed information on the eMC2 charging poles in section “Specifica-
tions” on page 30.
Includes
Your eMC2 charging pole comes with a range of components, which are necessary
for the proper installation and operation of the device. Therefore, please check imme-
diately after unpacking whether the following basic components are included:
Component Quantity Description
eMC2
charging pole 1
Charging pole, consisting of metal housing with
lockable cover
Installation and User
Manual
1
Instructions for mechanical and electrical instal-
lation as well as for taking the charging pole into
operation (this document)
Wiring diagram 1
Schematic of the supply connections and wiring
up of internal electronics
Sealing profile 1
Metal profile for sealing the gap between plinth
and pole with sealing tape
Installation kit 1
Blind cylinder including two M4 x 16 countersunk
head screws for installing a separately available
locking cylinder in the flip-out handle.
Inspection report 1
Report of the factory based operational test
Should one or more components be missing after unpacking, please contact your lo-
cal distributor immediately: You can find the necessary contact details on page ii
in this manual.
1605EMC444k
16-06-12
EMC444k
230/400V 50Hz 63A
IP44
IEC 61851-1
IEC 61439-7 ACSEV
MADE IN GERMANY
ABL SURSUM Bayrische Elektrozubehör GmbH & Co. KG
1605EMC44k000