ABL eMC2, Manual, Page: 22 / 44

INSTALLINg ThE ChARgINg pOLE
18
Mechanical installation of the plinth on alternative surfaces
In principle,
ABL
can only guarantee sufficient stability of the
eMC2
when properly
installed on the separately available EMC9999 foundation block.
DANGER!
For installations carried out on a concrete floor or foundation poured on
site there is a danger that high lateral forces will tear the eMC2 from
the ground.
The following description of installation is intended as an example and uses Würth
W-SA Ø 14 mm zinc plated steel bolt anchors to screw the eMC2 to a concrete sub-
strate complying with the specifications provided on page 33. Always select this or
another fixing method of equal mechanical strength!
For installation you will need the following components:
• EMC9998 or EMC9997 plinths (available separately)
• Four Würth DBL-(W-SA/S)-SW21-(A2K)-15-14x110 bolt anchors with large washers
(not included)
• Impact drill (not included)
• Drill bit for up to grade C50/60 concrete, matching Würth W-SA Ø 14 mm bolts (not
included, further information about fixings can be obtained from the manufacturer
at www.wuerth.de)
• Torque wrench suitable for W-SA Ø 14 mm hexagonal heads (size 21 mm, not in-
cluded)
• Drilling template for the eMC2 (included)
DANGER!
During the entire installation process, the safety switches for all supply
cables to the eMC2 must be deactivated: Supply cables must under all
circumstances be non-live and may only be reconnected to the electricity
grid for taking the device into electrical operation at the conclusion of the
installation process.
1. Use the drilling template to mark the four drilling holes at the installation site for
installing the plinth. Ensure that the supply cable is in the middle of the central
opening of the plinth.
• If you are using the EMC9998 plinth, mark the drill holes with a distance of 218
mm (widthwise) and 285 mm (lengthwise).
• If you are using the EMC9997 plinth, mark the drill holes with a distance of 89
mm (widthwise) and 285 mm (lengthwise).
2. Drill the fixing holes according to the manufacturer’s specifications for the recom-
mended Würth W-SA Ø 14 mm bolt anchors.
3. Clean the drill holes: For high strength, the drill holes should be as dust free as
possible.