Abicor Binzel xFUME POWER 250, Original Operating Instructions

Page: 56 / 72

EN - 20
6 Putting into operation xFUME
®
POWER 250
 Fig. 3 Control box on page EN - 13
6
Use the toggle switch (F) to thread in the welding wire until it protrudes from the welding torch’s contact
tip.

Fig. 6 Wire feeder on page EN - 18
7
Close the cover (A) .
6.3.4 Setting the contact pressure
CAUTION
Risk of injury
Physical injury caused by the start of the wire.
► Keep the process-side drive away from the body and do not direct it towards other people.
NOTICE
► The welding wire must not trail after.
NOTICE
► Set the contact pressure so that the welding wire (I) is not damaged and functions properly.
1
Open the cover.
2
Set the contact pressure with the clamping nut.
Ensure that the welding wire moves smoothly.
3
Close the cover.