ABB PRO-33.0-TL Series, Product Manual, Page: 81 / 136

Start-up 81
Comm control Commits the changes in the EFB
settings or activates the silent mode.
Enabled Normal operation.
Refresh settings Commits the modified EFB settings.
Reverts automatically to
Enabled .
Silent mode Activates the silent mode (no
messages are transmitted).
The silent mode can be canceled
with the
Refresh settings item.
Comm diagnostics
Bit positions:
Status of the EFB communication.
Read-only parameter.
0 – Init failed 1 = EFB initialization failed
1 – Addr config err 1 = Node address not allowed by
protocol
2 – Silent mode 1 = Inverter not allowed to transmit
0 = Inverter allowed to transmit
3 – Autobauding 1 = Inverter attempting to determine
transfer rate
4 – Wiring error 1 = Errors detected (Data+/Data-
wires possibly swapped)
5 – Parity error 1 = Error detected: Check the Baud
rate and Parity parameters.
6 – Baud rate error 1 = Error detected: Check the Baud
rate and Parity parameters.
7 – No bus activity 1 = 0 bytes received in last 5
seconds.
8 – No packets 1 = 0 packets (addressed to any
device) detected in last 5 seconds.
9 – Noise or addressing
error 1 = Errors detected: Interference or
another device online with the same
address.
10 – Comm loss 1 = 0 packets addressed to the
inverter received within timeout.
11 – CW/Ref loss 1 = No control word or references
received within timeout.
12 – Not active Reserved.
13 – Protocol 1 1 = Protocol-dependent status
information.
14 – Protocol 2 1 = Protocol-dependent status
information.
15 – Internal error 1 = Problem with the calls to the
inverter control program.
To set up the remote monitoring interface: