ABB HVC 200, Operation And Installation Manual, Page: 58 / 92

X1-1
X1-2
X1-3
A
A PE-neutral wire
6.4.2 Precommissioning mode - general procedure
Preliminary requirements
• The power cabinet is
mechanically installed.
Refer to section 6.2.1 .
• The power cabinet is
electrically installed. Refer
to section 6.3.1 .
• A separate
single phase 120 V AC
cable from the AC power
grid is available in the
power cabinet.
• There is no
3 phase 480 V AC power
supply from the AC power
grid.
•
Note: If the single phase 120 V AC cable from the AC grid is not installed,
contact the manufacturer. Refer to section 1.11 .
Procedure
1. Do an inspection of the PE connection. Refer to section 6.4.3 .
2. Connect the 120 V AC cable for the precommissioning mode. Refer to section
6.4.4 .
3. Do a check on the condition or the position of the electrical parts. Refer to
section 6.4.5 .
4. Set the precommissioning switch. Refer to section 6.4.6 .
Installation
58 HVC 200/300/360-EN | 002