ABB HVC 200, Operation And Installation Manual, Page: 41 / 92

6.3 Electrical installation
6.3.1 Electrical installation of the power cabinet - general procedure
Preliminary requirements
• The power cabinet and
other elements of the
system are machanically
installed on site.
• If the cable ducts are
used: the DC cables are
installed in one of the
cable ducts.
• If the cable ducts are
used: the AC cables, the
earthing wires and the
communication cables are
installed in the other cable
duct.
•
Procedure
1. Open the door of the power cabinet. Refer to section 10.1 .
2. Connect the PE wire and the AC cables to the power cabinet.
a. Remove the AC covers. Refer to section 10.5 .
b. Connect the PE wire to the power cabinet. Refer to section 6.3.2 .
c. Connect the AC input cable to the power cabinet. Refer to section 6.3.3 .
d. Connect the AC auxiliary output cable (3 phase 480 V) to the power cabinet.
Refer to section 6.3.4 .
e. Connect the AC auxiliary output cable (1 phase 120 V) to the power cabinet.
Refer to section 6.3.5 .
f. Install the AC covers. Refer to section 10.6 .
3. Open the DC door. Refer to section 10.7 .
4. Connect these cables to the power cabinet.
• Connect the DC power cables to the power cabinet. Refer to section 6.3.6 .
• Connect the DC auxiliary output cables to the power cabinet. Refer to
section 6.3.7 .
• Connect the interlock and DC guard cables to the power cabinet. Refer to
section 6.3.8 .
• If the charging interface uses ethernet cables, then connect the Ethernet
output cables to the power cabinet. Refer to section 6.3.9 .
• If the charging interface uses optical fiber cables, then connect the optical
fiber cables to the power cabinet. Refer to section 6.3.10 and 6.3.11 .
• Connect the long-distance kit optical cables to the power cabinet (option).
Refer to section 6.3.12 .
5. Close the DC door. Refer to section 10.8 .
6. Close the door of the power cabinet. Refer to section 10.2 .
Installation
HVC 200/300/360-EN | 002 41