ABB FSPS-21, User Manual

Page: 55 / 214

Default Description Name/Value No.
0 See parameter 02 FBA data out 1 . FBA data out 3 …
FBA data out12 03 ...
10
1) 11 (CW 32bit) is the default setting if the Transparent32 profile is used.
FSPS-21 configuration parameters – group C (group 3)
Note:
The actual parameter group number depends on the drive type. Group C (group 3)
corresponds to:
• parameter group 52 in ACS380 and ACS580
• parameter group 52 in ACS880 if the adapter is installed as fieldbus adapter A or group
55 if the adapter is installed as fieldbus adapter B.
Default Description Name/Value No.
4 or 14 1)
Selects the resolution of status word (16 bit or 32 bit)
sent by the drive. FBA data in 1 (drive
to master) 01
Status word (16 bits) 4 = SW 16bit
Status word (32 bits) 14 = SW 32bit
0 or 5 Selects data word 1 sent by the drive over the
PROFINET network. The content is defined by a
decimal number in the range of 0 to 9999 as follows: FBA data in 2 (drive
to master) 02
Not used 0
Virtual address area of drive control 1...99
Parameter area of the drive 101...
9999
Not used 0 = None
Status word (16 bits) 4 = SW 16bit
Actual value ACT1 (16 bits) 5 = Act1 16bit
Actual value ACT2 (16 bits) 6 = Act2 16bit
Status word (32 bits) 14 = SW 32bit
Actual value ACT1 (32 bits) 15 = Act1 32bit
Actual value ACT2 (32 bits) 16 = Act2 32bit
Status word 2 (16 bits) 24 = SW2 16bit
Parameter index with format xxyy , where 101…9999
• xx is the parameter group number (1…99)
• yy is the parameter number index within that group
(01…99).
Path to parameter area selection. Other
PROFINET IO – Start-up 55