ABB ACS880-87LC-3200A, Hardware Manual

Page: 114 / 132

Connector pitch 5 mm, wire size 2.5 mm
2
Analog outputs AO1 and AO2 (XAO)
0…20 mA, R
load
< 500 ohm
Frequency range: 0…500 Hz
Resolution: 11 bit + sign bit
Inaccuracy: 2% of full scale range
Connector pitch 5 mm, wire size 2.5 mm 2 XD2D connector
Physical layer: RS-485
Transmission rate: 8 Mbit/s
Cable type: Shielded twisted-pair cable with a twisted pair for data
and a wire or another pair for signal ground (nominal impedance
100 … 165 ohm, for example Belden 9842)
Termination by switch
Connector pitch 5 mm, wire size 2.5 mm
2
RS-485 connection (X485)
Physical layer: RS-485
Connector pitch 5 mm, wire size 2.5 mm 2 Safe torque off connection (XSTO)
Input voltage range: -3…30 V DC
Logic levels: “0” < 5 V, “1” > 17 V.
Note: For the converter to start, both connections must be “1”.
EMC (immunity) according to IEC 61326-3-1
Connector pitch 5 mm, wire size 2.5 mm
2
Safe torque off output (XSTO OUT)
Connector: RJ-45 Control panel connection (X13)
Cable length < 3 m
Connector: RJ-45 Ethernet connection (XETH)
Memory card type: SDHC SDHC memory card slot (SD CARD)
Maximum memory size: 4 GB
Connector pitch 5 mm, wire size 2.5 mm
2
CAN bus connection (XCAN)
Physical layer: CAN
Termination by jumpering XCAN:1 and XCAN:2 together
The terminals of the control unit fulfill the Protective Extra Low Voltage (PELV) requirements. The PELV re-
quirements of a relay output are not fulfilled if a voltage higher than 48 V is connected to the relay output.
114 BCU-x5 control unit