12
3M™MicroTouch™ System DST2270DX Integration Guide
3M Touch Systems, Inc. Proprietary Information – TSD-25739
Protective Material
Place anti-static protective material on the work surface. A padded surface protects
equipment from scratches during installation. Foam blocks can be used to support the
component side of the sensor and make for easier handling of the sensor panel.
Small Containers
Have several small containers (such as paper cups) available to hold screws, washers,
and other small components once you remove them.
Foam Pad
A foam pad is useful for holding the display while attaching the sensor. The pad makes
the sensor easier to rotate for fastening screws, taping, etc.
Identifying the Components
The following components are needed for a successful integration:
•
A 3M™ MicroTouch™ DST2270DX sensor and mated controller
•
A serial (7319630) or USB cable (7319420)
•
Molex 3-pin power connector crimp housing (22-01-3037) and
three terminals (08-50-0114)
•
Software and documentation found on the 3M Touch Systems website at
http://www.3Mtouch.com/
.
Note:
The DST sensor works exclusively with a mated DX123 controller for optimal
performance. Be sure to match the serial number on the sensor with the serial number on
the controller throughout the integration process.
Save the invoice, shipping container, and all packing material in case you need to
transport the equipment any time in the future.
