30
3M™MicroTouch™ System DST2270DX Integration Guide
3M Touch Systems, Inc. Proprietary Information – TSD-25739
Once the sensor is fully attached to the display secure the flex tail in place with a light
adhesive tape.
Inspect the Mounted Sensor
After you mount the sensor to the display, inspect your results carefully and check that
the sensor is installed properly.
1.
Set the display in its standard upright position.
2.
Look at the front of the display, and ensure the sensor flex tail exits from the top.
3.
Check for proper alignment. Make sure the sensor is not off-center or crooked. If the
sensor is not correctly aligned with the LCD panel, you must remove and remount
the sensor before you can continue with the installation.
4.
Look for dirt or lint trapped between the display and the sensor, as these particles
will be visible later.
If any part of the inspection fails, you must remove and remount the sensor.
Once you are satisfied with the alignment, you may cover the corners lightly (no
pressure) with cloth tape to keep out dust and dirt.
