Hard Hat Attachment Kit
Attaching/Detaching
43
Hard Hat Attachment Kit
The following instructions explain how to assemble and attach the hard hat kit to a standard hard hat.
Using a 3/32” hex wrench, twist the top shoulder bolt counterclockwise to loosen and remove the bolt
and the clip. Also, remove the bottom clip with the hex wrench. Once the bottom clip is removed, place
the shoulder bolt back into its place and tighten back up with the hex wrench.
Place the epaulette mount (see “A” above) into the top bracket of the Edge. Then slide the bolt into place
and tighten with a hex wrench. Then, the epaulette mount snaps onto the bottom shoulder bolt.
Slide the two prongs of the hard hat mount (see “B” above) underneath the epaulette mount (see “A
above) until it clicks into place.
4.
Taking the Edge with the assembled hard hat attachments, slide into the side of hard hat. It will fit
snuggly into the hard hat opening.
Shoulder bolt
Hex wrench
Epaulette
Shoulder bolt
Hard hat mount
attachment (The two
prongs slide into the
bottom cavity.)
Slide the two-sided prongs into
the hard-hat opening.
A
B
Hard Hat Attachment kit
A. Epaulette mount
B. Hard hat mount
Summary of Contents for Edge eg5
Page 9: ...viii This page left blank intentionally ...
Page 58: ...49 Appendix A Edge Block Diagram Analog Board ...
Page 59: ...50 Appendix A Edge Block Diagram continued ...
Page 68: ...59 Appendix C Appendix C Measurement equations APPENDIX C ...