![background image](http://html.mh-extra.com/html/3m/edge-eg5/edge-eg5_user-manual_442993031.webp)
Customizing set-up parameters in DMS
22
4.
For first time use of a docking station,
Welcome to the found new hardware wizard
will appear (see
Figure 2-8). Select
No
and press
Next
through the remaining wizard. At the end of the wizard, press
Finish
.
This will install the hardware components associated with your EdgeDock1 and/or EdgeDock5.
NOTE:
If you have more than one EdgeDock1 or EdgeDock5, this wizard will appear for each new
dock which is connected to your pc.
Figure 3-5: New Hardware wizard for Edge Dock
Customizing set-up parameters in DMS
Customizing and saving set-ups are performed via DMS. The following sections discuss each of the setup screens
and explain how to save and send the parameters to the dosimeter(s).
NOTE:
The following DMS settings apply to the eg5 model. If you are also using other models (eg3/eg4) and
have them docked in a 5-bay charger, they will appear in the “Edge Bay Charger” tree section, but no checkbox
will appear unless you first select the eg3/eg4 models radio buttons. The checkbox denotes that the models are
selectable when setup changes are applied and the “send setup to instruments” or “get identity” buttons are
selected.
Summary of Contents for Edge eg5
Page 9: ...viii This page left blank intentionally ...
Page 58: ...49 Appendix A Edge Block Diagram Analog Board ...
Page 59: ...50 Appendix A Edge Block Diagram continued ...
Page 68: ...59 Appendix C Appendix C Measurement equations APPENDIX C ...