![background image](http://html.mh-extra.com/html/3m/edge-eg5/edge-eg5_user-manual_442993036.webp)
Customizing set-up parameters in DMS
Saving and sending configurations
27
Saving and sending configurations
With the Edge, there are saved setup profiles used to quickly access and apply to The Edge(s). Below explains how to save
configuration settings in DMS and how to send to the instrument. Note: if you wish to only send the setup, please skip to step 3. Please
refer to this section as you setup your instrument.
1.
To save the Edge configuration in the software, click on a name in the
Configuration Profile Management
panel
(See 1). (Note:
The name will be shaded a light gray when selected.)
To create a new profile name, click and type in a profile name. Click
Save
. (It will save under the configuration profile
management panel).
2.
Click on the
button (see 2) and type in a
Name
. Click
Ok
.
Note:
This saves the configuration file in the software.
Or click button and rename the setting by typing in a name. Click
Ok
.
3.
To send to the instrument, select the (see 3).
Figure 3-11: Saving and sending Edge setups
2
3
4
Setups:
Click on the tabs to setup/view:
Dosimeter, Display, Security,
Auto Run, and Firmware Update
1
Summary of Contents for Edge eg5
Page 9: ...viii This page left blank intentionally ...
Page 58: ...49 Appendix A Edge Block Diagram Analog Board ...
Page 59: ...50 Appendix A Edge Block Diagram continued ...
Page 68: ...59 Appendix C Appendix C Measurement equations APPENDIX C ...