Customizing set-up parameters in DMS
Security setting
25
Security setting
The security setting is a type of “locking” feature (or secure run feature) that enables you to password protect the instrument to prevent
users from inadvertently terminating a study. Initially, this feature is set through the software and turned on once in run mode by pressing
run/stop key three consecutive times. (To unlock, press run/stop key three consecutive times and then press power key.) To set this
feature, please follow the steps below.
1.
Click on the
Security
tab from the Edge’s Instrument Configuration panel (see 1). To enable, click on the
Enabled
check box.
(Ensure the specific Edge is selected and communicating to the software. See “Communicating and downloading” for more
information.)
2.
Next, select either
Not Displayed
(see 2) or
Displayed
(see 3). Press Set
Configuration
to send the changes to the selected
instrument.
3.
To set the security settings, save and send to the Edge (for more details see “Saving and sending configurations”
.
Figure 3-8: Edge security setting
Auto Run setting
With the Edge auto run setting, you can program up to two
auto start
and
auto stop
configurations when start date and duration
parameters are enabled. This is useful if you wish to pre-set the instruments to run and stop for a specific time period, such as a week
long study. See steps below to enable.
1.
Click on the
Auto Run
tab from the Edge’s Instrument Configuration panel (see 1) and click in the
Enable
checkbox (see 2).
2.
To program
Date 1
, click in the
Enabled
checkbox and select a
Start Date
(by using the calendar icon or type in a date). Select
the
Duration
, by either typing in the time (designated in hours, minutes, and seconds) or using the up/down arrows (see 3).
(Repeat this step to setup a second Auto run mode. See 4.)
3.
To set
Auto Run
setting, save and send to the Edge (for more details see “Saving and sending configurations
”.
Figure 3-9: Edge auto run screen
1
2
2
3
4
3
1
Summary of Contents for Edge eg5
Page 9: ...viii This page left blank intentionally ...
Page 58: ...49 Appendix A Edge Block Diagram Analog Board ...
Page 59: ...50 Appendix A Edge Block Diagram continued ...
Page 68: ...59 Appendix C Appendix C Measurement equations APPENDIX C ...