![background image](http://html.mh-extra.com/html/3m/edge-eg5/edge-eg5_user-manual_442993035.webp)
Customizing set-up parameters in DMS
Firmware update
26
Firmware update
Edge firmware updates are performed in DMS when the instruments are docked, communicating, and the update key is selected. Please
follow the steps below prior to updating your Edge(s).
Note: this feature enables you to update all of your docked Edges (when powered
on and not in run mode).
1.
Click on the
Firmware
tab from the Instrument Configuration panel (see 1) and ensure to dock the Edge (or Edges) . Please read
steps under “Firmware Update” prior to updating (see 2).
Press button to refresh the docked instruments (if necessary).
2.
Press the button and please wait until the software states that it is
Done
. (Example of the message: ).
3.
To set, save and send to the Edge (for more details see “
Saving and sending configurations
”.
Figure 3-10: Edge firmware update screen
1
2
Summary of Contents for Edge eg5
Page 9: ...viii This page left blank intentionally ...
Page 58: ...49 Appendix A Edge Block Diagram Analog Board ...
Page 59: ...50 Appendix A Edge Block Diagram continued ...
Page 68: ...59 Appendix C Appendix C Measurement equations APPENDIX C ...