3D Systems sPro, User Manual

Page: 199 / 280

SLS p r o c e s s 1 9 9 S L S S Y S T E M
u s e r ’ s g u i d e S L S s y s t e m s e r v i c e & m a i n t e n a n c e
6
Replace the right side heater panel. To
replace, you must:
7
Align the three (3) locator tabs with their
respective slots.
8
Slide the panel forward into the slots,
lowering into place as you slide.
9
Connect the ground wire back in place.
10
Plug the power wire back into the panel
fitting.
11
Tighten the three (3) locking screws to secure
the panel in place.
Cleaning laser window
Clean the laser window before every build.
1
To remove the laser window lift the top panel
up.
2
Rotate the handle clockwise, this will trap
warm air in the build chamber.
3
Loosen the finger screws holding the window
in place.
4
Grab the laser window with both hands and
carefully slide unit out of system.
5
Place unit on flat surface with handle end up.
6
Using lens paper and ethanol carefully clean
optic. To do so drop ethanol on the lens
paper and dragging it across the optic.
Repeat, as necessary until the lens is clean.
7
Rotate window assembly over to clean the
other side.
8
Once unit is clean, reinstall into machine.
9
Tighten the finger screws
10
Rotate the handle counterclockwise
Cleaning the IR sensor and blackbody
The IR sensor should be cleaned before every
build. Cleaning the sensor can be done through
either method listed below.
METHOD 1
1
Using a T20 driver, remove the two screws
located on the IR block. The IR block is
located on the right side of the machine and
houses the IR sensor.
2
Using lens paper and ethanol carefully clean
the optic of all material.
3
Reinstall IR blocks assembly and secure with
T20 driver.
METHOD 2
1
Unload and remove RCM.