29
3D Systems, Inc
.
4 . Apply two (2) thin layers of glue to the center of the plate . Select the
checkmark
to continue .
NOTE: For more information, refer to the section titled
Applying
Cube Glue
.
NOTE: For small print file sizes, use a light coating of glue.
If the file size is larger, a slightly thicker coating of glue is
recommended . When the printer begins to print, the glue surface
should be mostly dry . The temperature from the molten plastic will
melt the surface of the glue increasing its adhesion .
NOTE: Ensure that the area where glue is applied is larger than the
base of your creation .
NOTE: The estimated time to completion is noted at the bottom of
the screen .
NOTE: When printing with only ABS material, the print chamber
will need to build and maintain a predetermined temperature .
Ensure the top cover and the back panel have been installed . The
front door must be closed .
NOTE: When printing with PLA only or both PLA and ABS material,
the print chamber will not need to be preheated .
NOTE: The print jets required for the print job will begin to heat .
CAUTION: Do not touch the print jets until they have cooled to
room temperature .
