3Com Switch 5500 Family
41
Quick Reference Guide
port hybrid pvid vlan
Use the
port hybrid pvid vlan
command to configure the default VLAN ID of the hybrid port.
Ethernet Port view
port hybrid vlan
Use the
port hybrid vlan
command to add the port to the specified VLAN(s). The port needs to have been
made a hybrid port before you can do this. See the related command below.
Ethernet Port view
port isolate
Use the
port isolate
command to add a port to an isolation group using the following commands, and
achieves port-to-port isolation between this port and other ports of this group, that is, Layer 2 forwarding
between the isolated ports is not available.
Ethernet Port view
port link-aggregation group
Use the
port link-aggregation group
agg_id
command to add an Ethernet port into a manual or static
aggregation group.
Ethernet Port view
port link-type
Use the
port link-type
command to configure the link type of the Ethernet port.
Ethernet Port view
port-security enable
Use the
port-security enable
command to enable port security.
System view
port-security intrusion-mode
Use the
port-security intrusion-mode
command to set the action mode of the Intrusion Protection
feature.
Ethernet Port view
port-security max-mac-count
Use the
port-security max-mac-count
command to set the maximum number of MAC addresses allowed
to access the port.
Ethernet Port view
port-security ntk-mode
Use the
port-security ntk-mode
command to set the packet transmission mode ofthe Need to Know
(NTK) feature.
Ethernet Port view
port-security OUI
Use the
port-security OUI command
to set an OUI value for authentication.
System view
port-security port-mode
Use the
port-security port-mode
command to set the security mode of the port.
Ethernet Port view
port-security timer disableport
Use the
port-security timer disableport
command to set the time during which the system temporarily
disables a port.
System view
port-security trap
Use the
port-security trap
command to enable the sending of the specified type(s) of trap messages.
System view
port-tagged
Use the
port-tagged
command to configure VLAN check on the management device for the
communication inside a cluster.
Cluster view
port trunk permit vlan
Use the
port trunk permit vlan
command to add a trunk port to one VLAN, a selection of VLANs or all
VLANs.
Ethernet Port view
port trunk pvid vlan
Use the
port trunk pvid vlan
command to configure the default VLAN ID for a trunk port.
Ethernet Port view
