3Com Switch 5500 Family
Quick Reference Guide
info-center timestamp loghost
Use the
info-center timestamp loghost
command to set the format of time stamp to be sent to log host.
System view
info-center trapbuffer
Use the
info-center trapbuffer
command to output information to the trap buffer.
System view
instance
Use the
instance
command to map specified VLANs to a specified spanning tree instance.
MST Region view
interface
Use the command
interface
interface_type interface_number
to enter the interface of the
specified port.
System view
interface VLAN-interface
Use the
interface vlan-interface
command to enter a VLAN interface view and use the related
configuration commands.
System view
ip address
Use the
ip address
command to configure either the primary or secondary IP address and IP subnet mask
for a VLAN interface.
VLAN Interface view
ip address bootp-alloc
Use the
ip address bootp-alloc
command to configure VLAN interface to obtain IP address using
BOOTP.
VLAN Interface view
ip address dhcp-alloc
Use the
ip address dhcp-alloc
command to configure VLAN interface to obtain IP address using DHCP.
VLAN Interface view
ip host
Use the
ip host
command to configure the host name and the host IP address in the Switch 5500’s host
table. This allows you to ping or Telnet a local device by host name.
System view
ip http acl
Use the
ip http acl
command to call an ACL and perform ACL control over the WEB network
management users.
User Interface view
ip ip-prefix
Use the
ip ip-prefix
command to configure an address prefix list or one of its items.
System view
ip-pool
Use the
ip-pool
command to configure a private IP address range for cluster members on the switch to
be set as the management device.
Cluster view
ip route-static
Use the
ip route-static
command to configure a static route, whose validity depends on detecting results
as follows: valid when the detecting result is reachable or invalid when the detecting result is unreachable.
System view
jumboframe enable
Use the
jumboframe enable
command to allow jumbo frames to pass through the specified Ethernet port.
Ethernet Port view
key
Use the
key
command to configure a shared key for HWTACACS authentication, authorization or
accounting.
HWTACACS view
lacp enable
Use the
lacp enable
command to enable LACP.
Ethernet Port view
